Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Qbasics for Windows
#16
(02-07-2008, 02:48 AM)Ralph link Wrote:...Everything proceeds fine, until I get to the point where I press "I" to install 7.1...then, it asks me to insert Disk 1 in drive C:.  I enter "c", for Continue, and I can't proceed! Do you have any suggestions?

I did test again the Setup to be able to answer you. I found that All the files must be in the 'Root' of a partition or harddisk but Not into a temporary directory. Then it will run completely.

(02-07-2008, 02:48 AM)Ralph link Wrote:...I'm hoping that "far memory" refers to a good chunk of the 512 MB of memory in my computer! I hope.

I think it's only the 640 Kbs. area. To use 64 Mbs. it is needed a program for the EMS like This, for example.
MY QBASIC'S PAGE                                                  I ONLY USE WINDOWS 98SE
Reply


Messages In This Thread
Qbasics for Windows - by Opresion - 09-19-2007, 04:49 PM
Re: Qbasics for Windows - by Opresion - 09-19-2007, 05:05 PM
Re: Qbasics for Windows - by Opresion - 09-19-2007, 05:09 PM
Qbasics for Windows - by Opresion - 09-19-2007, 05:13 PM
The Qbasics for Windows - by Opresion - 10-01-2007, 04:13 PM
Re: Qbasics for Windows - by Ralph - 01-10-2008, 09:56 AM
Re: Qbasics for Windows - by Ralph - 01-13-2008, 12:29 AM
Qbasics for Windows - by Opresion - 01-30-2008, 05:13 PM
Re: Qbasics for Windows - by Ralph - 01-31-2008, 06:58 AM
Qbasics for Windows - by Opresion - 02-01-2008, 01:05 PM
Re: Qbasics for Windows - by Ralph - 02-02-2008, 04:50 AM
Re: Qbasics for Windows - by Ralph - 02-02-2008, 10:40 AM
Re: Qbasics for Windows - by Opresion - 02-06-2008, 12:35 PM
Qbasics for Windows - by Opresion - 02-06-2008, 12:46 PM
Re: Qbasics for Windows - by Ralph - 02-07-2008, 02:48 AM
QBasics for Windows - by Opresion - 02-08-2008, 12:29 PM
Re: Qbasics for Windows - by Ralph - 02-09-2008, 07:31 AM
Qbasics for Windows - by Opresion - 02-17-2008, 02:32 PM
Re: Qbasics for Windows - by Ralph - 02-18-2008, 07:50 AM
Qbasics for Windows - by Opresion - 02-18-2008, 12:19 PM
Re: Qbasics for Windows - by Ralph - 02-19-2008, 07:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)