Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Difference /Q and /QU
#1
I do not remember when but I saw a post talking about the difference betwen /Q and /QU when they are used with the Linker.

I can not find it because the searcher of this page ignores the slash. Who remembers where is it? or who can explain to me the meanings of /QU?
MY QBASIC'S PAGE                                                  I ONLY USE WINDOWS 98SE
Reply
#2
(06-11-2008, 03:02 PM)Opresion link Wrote:I do not remember when but I saw a post talking about the difference betwen /Q and /QU when they are used with the Linker.

I can not find it because the searcher of this page ignores the slash. Who remembers where is it? or who can explain to me the meanings of /QU?
According to my manual, when used for the Linker, /Q is the same as /QUICKLIB. This option tells the linker to combine the object files you specify into a Quick library.

The manual does not specify any /QU option. I suspect that /QU would be the same as /Q, since they are both abbreviations of /QUICKLIB.

Good luck, and regards .... Moneo

Reply
#3
The only reference to /QU in the QuickBasic Knowledge Base I could find was this one:
http://kb.qbasicnews.com/Q41004.TXT

I think the forum post you're looking for was posted under the old forum, still viewable here:
http://oldforum.qbasicnews.com/viewtopic.php?t=7338

- Dav
Reply
#4
(06-12-2008, 05:37 AM)Dav link Wrote:The only reference to /QU in the QuickBasic Knowledge Base I could find was this one:
http://kb.qbasicnews.com/Q41004.TXT

That's the answer; previously I wasn't paying enough attention; the difference it's that when one is making a Quickbasic library and displays an 'Unresolved External' message, one can use the /QU to ignore the problem and to finish the library.

Thank you very much for the solution.
MY QBASIC'S PAGE                                                  I ONLY USE WINDOWS 98SE
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)