Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3D Art Challenge XII ((Challenge))
#40
being a welder and a hobby smith, if you temper your steel right
the core will stay soft while the shell is tool steel hard,
and if it does break it will only crack, at that point you just
braze the crack to allow the stressflow lines to realine and
strengthen back up!
t is better to error on the side of caution
than the side of haste!!!
[Image: title3.jpg]
Reply


Messages In This Thread
3D Art Challenge XII ((Challenge)) - by Deleter - 07-02-2006, 12:14 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-02-2006, 12:56 AM
3D Art Challenge XII ((Challenge)) - by Zap - 07-02-2006, 02:41 AM
3D Art Challenge XII ((Challenge)) - by Deleter - 07-02-2006, 06:05 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-02-2006, 07:09 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-02-2006, 07:10 PM
3D Art Challenge XII ((Challenge)) - by Deleter - 07-03-2006, 02:46 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-03-2006, 04:21 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-03-2006, 05:18 AM
3D Art Challenge XII ((Challenge)) - by Deleter - 07-03-2006, 01:05 PM
3D Art Challenge XII ((Challenge)) - by Anonymous - 07-03-2006, 02:17 PM
3D Art Challenge XII ((Challenge)) - by DrV - 07-03-2006, 09:11 PM
3D Art Challenge XII ((Challenge)) - by Anonymous - 07-04-2006, 12:14 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-05-2006, 07:22 PM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-06-2006, 12:05 AM
3D Art Challenge XII ((Challenge)) - by Torahteen - 07-06-2006, 05:32 AM
3D Art Challenge XII ((Challenge)) - by phycowelder - 07-08-2006, 07:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)